PG

Home

  • ESP32-DevKitC

    ESP32-DevKitC is a low-footprint and entry-level
    development board that is part of the ESP32 series.
    This board has a rich peripheral set. The built-in
    ESP32 pinout is optimized for hassle-free
    prototyping!

Key Features

Wi-Fi & Bluetooth Connectivity

This minimum-system development board is powered by an ESP32 module. It integrates Wi-Fi and Bluetooth functions, and provides a rich peripheral set for rapid prototyping!

Rapid Prototyping

ESP32-DevKitC achieves optimal RF performance. You can get right into application design and development, without worrying about RF performance and antenna design. ESP32-DevKitC has your basic system-requirements already covered. Just plug in the USB cable and you are ready to go!

Flexible and Feature-Rich

ESP32-DevKitC contains the entire support circuitry of ESP32-WROOM series, ESP32-WROVER series, and ESP32-SOLO series of modules, also including a USB-UART bridge, reset- and boot-mode buttons, an LDO regulator and a micro-USB connector. Every important GPIO is available to the developer.

Breadboard-Friendly

The ESP32-DevKitC pinout is optimized to enable prototyping on a breadboard. The on-board LDO output is led out for powering up additional off-board electronics. Peripheral outputs are grouped together for hassle-free prototyping.

Amazon-Qualified Device

ESP32-DevKitC development boards are qualified by Amazon Web Services (AWS). In addition to Espressif’s own IoT development framework, ESP-IDF, you can use FreeRTOS on ESP32-DevKitC. FreeRTOS provides out-of-the-box connectivity with AWS IoT, AWS Greengrass and other AWS services.

Getting Started with FreeRTOS

Comparison of Parameters

Boards

ESP32-DevKitC-32E

ESP32-DevKitC-32UE

ESP32-DevKitCVE

ESP32-DevKitCVIE

ESP32-DevKitCS1
Related Module ESP32-WROOM-32E ESP32-WROOM-32UE ESP32-WROVER-E ESP32-WROVER-IE ESP32-SOLO-1
Flash / PSRAM 4 MB Flash 4 MB Flash 8 MB Flash + 8 MB PSRAM 8 MB Flash + 8 MB PSRAM 4 MB Flash
Antenna PCB IPEX PCB IPEX PCB
PG